Annex E (informative) — A-100 reference figures

Where EIS restates the Doepfer A-100 pages, and where it differs from them.

E.1 Construction details

Doepfer publishes Construction Details A-100, retrieved 2026-10-09. EIS restates some of its figures as inherited requirements; it does not apply the page by reference. The A-100 check compares selected figures with EIS.

Figure on the page Value EIS requirement Provenance
3U front panel height 128.5 mm PANEL-006, 128.5 mm inherited
Front panel mounting-hole inset 3.0 mm PANEL-008 inherited
Front panel mounting-hole drill Ø3.2 mm PANEL-010 inherited
Front panel thickness 2 mm PANEL-004, at most 2.0 mm; EIS recommends 1.6 mm to 2.0 mm inherited; EIS
Front panel widths below N × 5.08 mm PANEL-002, at most N × 5.08 mm for any positive whole N; EIS recommends 0.3 mm below inherited; EIS
Mean front panel width gap 0.309 mm The 0.3 mm width clearance EIS recommends EIS

The panel figures EIS derives from these are in 5.2.1.

E.2 Technical details

Doepfer publishes Technical Details A-100, retrieved 2026-10-16. The signal check quotes its figures and reports where EIS differs. The page's patch levels are typical ranges; modules in use exceed them, and an input has to accept what an output may send, so EIS sets audio and control CV at ±10 V peak.

Figure on the page Value EIS class Provenance
Audio typically 10 Vpp (−5 to +5 V) MOD-AUDIO ±10 V peak EIS
LFO −2.5 to +2.5 V MOD-CV at range B5 (±5 V) EIS
ADSR 0 to +8 V MOD-CV at range U10 (0 to +10 V) EIS
Gate, trigger, clock typically 0/+5 V; above about +3 V is high, below 1 V is low; withstands up to +12 V MOD-GATE high ≥ +3 V, low ≤ +1 V; BUS-GATE 0/+5 V inherited
Pitch CV 1 V per octave; no CV value is assigned an absolute pitch MOD-CV-1VOCT 1.00 V/octave, 0 V = C0 (the reference is EIS's); BUS-CV 1 V/octave EIS; inherited
Input and output impedance not stated 1 kΩ source, 100 kΩ load EIS