videomancer beta program

Archived RC: 1.0.0-rc.40

Program-library upload reliability (watchdog during SD writes); verify Connect pack install and no dual RGB 1V / HDMI regression vs rc.39

Before you test

Install LZX Connect 1.3.5 and enable Show pre-release firmware
Flash 1.0.0-rc.40 (Connect update or .uf2 from Downloads)
Confirm 1.0.0-rc.40 on the SYSTEM screen
Dual-capable cable set: HDMI in + Analog Out looped to Analog In (YPbPr AC and RGB 1V DC jacks as needed)

Program library upload — no mid-transfer reset
high
1. Connect 1.3.5+; enable Show pre-release firmware. 2. Flash 1.0.0-rc.40 if not already on device. 3. Install or refresh an official program pack (Programs tab). 4. Retry a large pack if one failed on rc.39 / Connect 1.3.4.
Pass: Pack install completes without device reset, broken pipe, or comm error; programs appear and load.
Dual RGB 1V — color bars regression
high
1. Routing = Dual; Analog Out/In = RGB 1V. 2. Passthru color bars at 720p60 and 1080p30.
Pass: Same usable picture as rc.39; no new level or color regression.
HDMI + standalone smoke
medium
1. Routing = HDMI; passthru bars — lock OK. 2. Routing = Standalone; colorbars at one progressive rate.
Pass: No blank or unlock regression vs rc.39.