videomancer beta program

Before you test

• Flash 1.0.0-rc.67 UF2 (full image)
• Official 1.0.8-rc.1 and community 1.0.6-rc.1 already installed is fine

Testing goals

• Audio In follows jack 1 across the frame

  high

  1. HDMI in and HDMI out. One CV patched into rear jack 1. 2. Set one program parameter to Audio In. Channel must read Ch1. 3. Sweep the CV from low to high.

  Pass: That parameter follows the voltage for the whole frame. The picture does not stripe or step through other parameters.

• Unassigned parameters stay put

  high

  1. Same patch as the jack-1 goal. Only one parameter is Audio In. 2. Sweep the CV.

  Pass: Parameters that are not Audio In stay at their knob values.

• Channel survives Audio In and CV Input

  high

  1. On an Audio In slot, set Channel to Ch2. 2. Switch the source to CV Input, then back to Audio In.

  Pass: Channel stays Ch2. The slot reads rear jack 2.

• Picture after boot

  medium

  1. After a normal boot, connect HDMI out with Passthru loaded.

  Pass: A picture comes up.

Report feedback