videomancer beta program

Archived RC: 1.0.0-rc.68

Auto is the default for video route and analog in; HDMI beats analog beats standalone, and SD composite burst selects CVBS under analog Auto

Before you test

Factory reset opens on Auto
high
1. Factory reset or flash a unit with no saved route/analog keys. 2. Open Settings → Vid Route Mode and Analog In Mode.
Pass: Both menus show Auto. A unit that previously saved Analog In (0) and Composite (0) still shows those after the update.
HDMI over analog over standalone
high
1. Set Vid Route Mode to Auto. 2. Connect HDMI and an analog source; confirm HDMI input on the home label. 3. Unplug HDMI; confirm analog takes over. 4. Unplug analog; confirm standalone synthesis.
Pass: Priority matches HDMI → analog → standalone. Dual never appears unless chosen explicitly. At most one bitstream load when a source is present at cold boot.
Analog Auto picks CVBS vs YPbPr
high
1. Vid Route Analog or Auto with analog winning; Analog In Mode Auto. 2. Feed NTSC or PAL composite on the shared Y/CVBS jack. 3. Switch to component or HD on the same path.
Pass: SD color composite becomes CVBS (home label CVBS). Component/HD/ED and B&W SD stay YPbPr. RGB 1V / SOG selections do not change by themselves.
Explicit Standalone still isolates idle sync
medium
1. Set Vid Route Mode to Standalone (not Auto). 2. Leave a composite cable on the jack with no intended input.
Pass: Sync Out / timing behavior matches rc.67 explicit Standalone (L5 idle), not Auto standalone STDI watch.